Intermediate frequency pipe bending machine maintenance and maintenance
1, when cleaning tank, to wash the pump inlet filter intermediate frequency pipe bending machine.
2, 1-2 months after the equipment start using, intermediate frequency pipe bending machine cleaning tank and filter the hydraulic cases at a time.
3, check each part fasteners, in a state of fastening.
4, advance and retreat cut failure is found, first check whether the electromagnetic valve movement such as solenoid valve movement is normal, check sequence valve unidirectional unloading valve, relief valve or have any impurity stuck phenomenon.(this kind of phenomenon generally began to use the device easily happen).If you have stuck phenomenon, open clean with gasoline or diesel intermediate frequency pipe bending machine, can be installed again.
5, hydraulic pump station parts of each joint are equipped with oil resistant rubber sealing ring, such as sealing ring damage, oil, should be timely replacement. |
