The detailed introduction of the elbow machine
Elbow machine drive system of machine, hydraulic pump station, control board, electrical control cabinet, intermediate frequency power supply, water, cable, compensation capacitor, reactor, intermediate frequency coil mediation.Will cut a good raw material set on elbow mold core rod, the intermediate frequency feel line trap at the end of elbow mold core head, start the cooling water pump and intermediate frequency power supply, the original material is heated to a certain degree, then start the elbow push system machine began to push system.
Credentials are pushing elbow main pump selection, the selected speed feeding, sluice gate, the mandrel is heated to temperatures began to push things, things pushing speed is adjustable, push to the midpoint push machine stop actively, hydraulic gate lock, died on the core rod, loosen the lock to retreat to the end, gate lock to stem diameter began to advance.Note: when the main pump things can use at the same time, as usually environment using only one can.Needless to stop also can be used as a retreat.Retreat pump can't use at the same time, can only start one, the other a backup.Feeding pump is only used when feeding.Quiet pressure adjustable hydraulic system as the main pump, oil cylinder hydraulic system pressure adjustable quiet as the attached.Push the machine schedule trip switch installed at both ends, real stroke should be less than the largest stroke, is a sport push board both before and after the head away from the real endpoint leave some allowance, in order to avoid the oil cylinder piston moves. |
