Elbow machine operation process
Do it carefully before operation
1, the elbow machine must be good grounding, copper wire should not be less than 4 was a cord.Are not allowed to access the voltage of power supply in excess of the prescribed scope, not charged plug plug-in, cannot use megger test control loop, otherwise may damage the device.
2, when the plug connectors, cannot, drawing wire or cable to prevent welding pulled off.
3, close to switch, encoders cannot use hard objects such as the impact.
4, with no sharp collision display unit.
5, electrical box must be placed in ventilated place, forbid working in dust and corrosive gas.
6, shall not be mounted, to connect the PC input and output side.
7, exchange machine power supply must reconfirm motor turning.
|
