| Elbow machine high temperature need to pay attention to what?
Work flow of elbow machine:
Operate pushing machine in strict accordance with operating procedures.
Check the belt regularly. If the handle, knob or button is damaged or seriously worn, it should be replaced in time and reported for spare parts supplement. Check the repair switch regularly. . Safety. Handle. To ensure its reliable work.
Before starting each elbow machine, timing according to lubrication chart requirements. Fixed point. Quantitative add lubricating oil, oil should be clean without precipitation. Lubricate and scrub the elbow machine 10 minutes before leaving work every day.
Non-designated personnel are prohibited to operate the equipment, usually must leave the machine to stop. The propulsion must always be kept clean and part of the antirust oil is not painted.
The lubricating oil in the motor bearing should be replaced and refilled regularly, and the electrical parts should be checked regularly whether they are normal, stable and reliable.
Elbow machine in the cutting material temperature is very high, some flammable substances, such as chemical fiber clothing. Keep the documents close to the cutting steel plate or cutting gun to avoid fire.
The cutting site can not store high temperature explosive things, such as gas cylinders. Try not to leave the trachea at the cutting site. When in use or in use, the air pipe and power line control bracket should be suspended in the air, not placed on the guide rail or cutting plane, to avoid damage and confusion.
Turn off the power after use. Air source and panel should be wiped clean to ensure next use.
Guide rail. Rack when used, friction is easy to generate heat. Once the heat is too high, it will affect the material of the parts. In order to avoid excessive heat, greasy oil should be added before use.
After cutting the steel pipe at high temperature, there is enough heat left on the pipe to hurt the skin. Therefore, don't worry about touching it with your hands after cutting. After the steel pipe is completely cooled, it can be touched by hand or cut with mechanical equipment.
| 