| Elbow push machine function
Machine according to the customer order of elbow push system equipment, our company main pump to push the machine selection, the selected speed feeding, sluice gate, mandrel heated to working temperature began to advance, elbow push system in the work of the machine can automatically stop, hydraulic gate lock die, core rod feeding, loosen the back gate to the finish line, gate valve and began to push rod diameter.
The main push pump of the elbow push machine can be used at the same time, generally only one can be used. Can also be used to retreat without stopping. Backward pump can not be used at the same time, only one can be started, the other standby. Feeding pump can only be used for feeding. The stable pressure of the hydraulic system of the main oil pump and the hydraulic system of the auxiliary cylinder shall be set as. Both ends of the elbow push machine stroke are equipped with a stroke switch, the actual stroke should be less than the large stroke, that is, the two ends of the active push plate from the actual end point are left some allowance, so as not to run the cylinder piston.
Elbow push machine function: elbow push machine equipment composition of elbow push machine host, hydraulic pump station, operating table, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjustment frame, reactor. The working principle of the equipment: the cut raw material is set on the elbow mold core rod, the intermediate frequency induction line is trapped in the end of the elbow mold core, start the cooling water pump and the intermediate frequency power supply, heat the raw material to about 800°C, and then start the push machine to push the elbow.
Elbow pusher machine host, hydraulic pump station, control table, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil mediation frame, reactor.
The cut raw material is set on the elbow mold core rod, the intermediate frequency induction line is trapped in the end of the elbow mold core, start the cooling water pump and the intermediate frequency power supply, heat the raw material to a certain temperature or so, and then start the push machine to push the elbow.
The company mainly produces elbow push machine, intermediate frequency bending machine, intermediate frequency elbow, hydraulic tee machine, intermediate frequency expanding machine, straight seam welding pipe production line, groove machine, straightening machine, mold and so on. Welcome your consultation!
|
