| The main use of intermediate frequency pipe bender
Intermediate frequency pipe bender refers to the machine used for bending pipe can also do jack, roughly divided into NUMERICAL control pipe bender, hydraulic pipe bender, etc., used in power construction, railway construction, Bridges, ships and other aspects of pipeline laying and construction.
Intermediate frequency pipe bending machine can be roughly divided into hydraulic pipe bending machine and NUMERICAL control pipe bending machine, which is mainly used for power construction, bridge, highway construction, railway construction, ship and other aspects of pipeline construction and laying, and it has many functions, simple operation, reasonable structure and other characteristics.
The following is about the operation rules of the intermediate frequency pipe bender. In front of the tube bending machine operation to ensure that the machine is the production of bend of grounding, and soft copper conductor is not less than 4 mm 2 line, does not allow access to overrule the size of the power supply voltage, and in the intermediate frequency of pipe bender homework time stop charged plug plug-in, can not use a megger test control loop, because this can make the device damage. Do not pull out the cable or wire when inserting and removing the connector plug of the intermediate frequency pipe bender, which will form welding pull off. When close to the switch of the pipe bender, hard objects can not be used to hit the encoder, and sharp objects can not be used to support the collision display unit. The electrical box of the intermediate frequency pipe bender must be placed in a ventilated place. It is not allowed to be placed in the dust and corrosive gas for operation, and it can not be installed or changed to the INPUT and output value of the PC side without permission. When exchanging the power supply of the pipe bending machine, it is necessary to re-admit the steering of the motor. The machine tool of intermediate frequency pipe bender should be kept clean, and special attention should be paid to the condition of the clamping block, slide block and other sliding groove inside. If foreign bodies are found, they should be sorted out in time. To regularly add smooth oil to the chain and other sliding parts of the intermediate frequency pipe bender, together with the cleaning and maintenance of the pipe bender must be disconnected from the power supply, so as to avoid accidental attacks. Before starting the intermediate frequency pipe bender, check whether the oil level of the oil strip is to the oil level line, refueling at each smooth point, be sure to admit the steering of the motor before starting up, check whether the oil pump has abnormal sound, and check whether the hydraulic system has the appearance of oil leakage after starting up.
|
