| Tee machine is the first choice of tee fitting manufacturers
Three-way machine design structure introduction: three-way machine overall frame fuselage optimization design to ensure strength, welding parts for non-destructive testing, aging treatment after welding, to ensure that stress elimination, equipment in use without deformation. T groove is arranged below the slide block and above the table for installing the mold. A dead point locking device on the slide block is provided to prevent the slide block from sliding. The power structure is placed on the top of the machine, and the top of the fuselage is provided with a safe platform and fence. The slide rail is lubricated by non-recovery automatic flow thin oil, and is equipped with oil receiving box and fault display device.
Three-way machine is the production of three-way pipe fittings advanced technology equipment, mainly who squeeze into three-way pipe fittings, reduce filling lead, drilling and other processes. Three way machine in the production of three way pipe fittings is mainly to save cost and production time, for customers to produce customers need three way pipe fittings products. The uniform wall thickness of the three way pipe fittings at the production place of the three way machine ensures the quality.
The three-way machine has a three-way solenoid valve in each wheel pump. The three-way solenoid valve has three boosting processes, holding pressure and reducing pressure. The boosting process: There is no current flowing in the electromagnetic coil, the solenoid valve is in the boost position at the moment the brake pump and the wheel pump are connected, the brake fluid from the brake pump directly flows to the wheel pump, the pressure of the wheel pump changes with the pressure of the main pump, at the moment the ABS system does not work, the return pump does not work. Pressure holding process: when the electromagnetic coil into a small insist current is about half of the current when the solenoid valve is in the insist pressure direction, all channels are cut off. Tee machine decompression process: when through the electromagnetic coil current value, plunger moved to the top, the access of the master cylinder and wheel cylinder is cut off, the electromagnetic valve in the reduced pressure bearing, solenoid valve at the moment will be the same wheel pump and oil return channel or and receiver are interlinked, make the wheel brake fluid flows through the electromagnetic valve of pump, into the receiver, lower the wheel brake pressure pump agility.
Our company is mainly a variety of pipe fittings equipment and mechanical equipment, 24 hours welcome your consultation order!
|
