| The composition and maintenance of elbow machine
Bend machine mainly include alloy core head, intermediate frequency coil bracket, intermediate frequency coil, export support, push the door, open hydraulic oil cylinder, push board, after the gate, the hydraulic lift cylinder, the main oil cylinder, cylinder bracket, after feeding the core rod, the big chassis, oil cylinder bracket, motor, steering pump, manifold blocks (such as installation of the hydraulic control valve) above combination. The above is a brief introduction to the composition of the elbow machine. Welcome new and old customers to consult elbow machine in detail.
Medium frequency elbow machine is used for elbow forming, the main power is hydraulic cylinder, heating mode is medium frequency heating (in addition to the use of coal stove and natural gas heating) elbow diameter from 21mm-1620mm, wall thickness from 3mm-120mm. Medium frequency elbow machine is mainly used for carbon steel and alloy steel elbow molding, if you need stainless steel elbow products, please choose our company's cold push elbow machine.
Elbow machine, hydraulic push machine under normal circumstances, should be maintained once a month or so.
The bending machine is checking the fasteners in all parts to make them in tight state. Oil resistant rubber sealing rings are installed in each joint of hydraulic pump station of elbow machine. Such as sealing ring damage, oil leakage, should be replaced in time.
If it is found that the elbow machine forward and backward failure, first check whether the solenoid valve action, such as normal solenoid valve action, check whether the overflow valve or check valve impurities stuck phenomenon, disassemble with gasoline or diesel cleaning, reinstall can be.
Clean the oil tank and filter the hydraulic tank once within 1-2 months after the elbow machine is in use. When cleaning the tank, clean the inlet oil filter of each pump.
|
