| The routine operation technology of pipe bender
In the process of production, the pipe bender first needs to check the normal use and operation process of the pipe bender, and input the Angle and diameter of the steel pipe that needs to be bent into the control system of the pipe bender, so that it can continuously make customized elbow pipe when producing the elbow. Adjust the bending effect in the production process, must consider to adjust the amount of joker to effect, after the adjustment type arc bending and sharp pipe length change rate, the degree of circular arc bending pipe is always in the wrong is always after the rain of the pipeline length, adjust the quantity is a size and bending Angle of the radius of the pipe bending machine. Such a pipe bender in the production process: simple operation, high production efficiency, low cost and excellent characteristics.
When the pipe bender is in use: refer to the operation manual of electric oil pump. Now screw the working oil tank into the inner thread of the square gear block, and the wheel mounted on the bracket at the back end of the oil cylinder is downward. Choose die according to the bending tube diameter, the fortress, set the column will be two roll groove which corresponds to the die, and then put into the corresponding size of the air, flower board cover plate on the diameter, the bending tube inserted into the slot, jiang in the high pressure oil pipe end quick joint activities section back and set on the joint of cylinder, the oil drain screw on the electric pump tighten, can bend. After the bend is completed, loosen the screw and the plunger will reset automatically.
Our company mainly produces pipe fitting equipment: bending machine, elbow machine, tee machine, pipe expanding machine, press machine, groove machine, straight seam welding pipe production line and other pipe fitting equipment. The above pipe fitting equipment is mainly used in the pipeline installation process.
765
|
