How to operate a intermediate frequency pipe bending machine
According to the working experience in mechanical workers, we will briefly introduce the safe running of the intermediate frequency pipe bending machine in China.
1, on site inspection, remove all getting in the way of work and the clutter of transportation.There can be no oil in the ground to avoid slipping.Artifacts are stacked neatly and companies, in order to prevent collapse.
2, check the intermediate frequency protection device on the pipe bending machine in good condition, if not installed, it is not allowed to drive.Intermediate frequency pipe bending machine should have a good grounding and electrical insulation, voltage should be stable.
3, check the intermediate frequency pipe bending machine, oil should be added when short of oil, oil free.
4, when the empty test run, check whether the machine is normal operation, electric switch is sensitive to use.Is everything all right, then.
5, when two people at the same time should work in close cooperation, coordination.You should specify a switch operation.Operation is not allowed to talk with others, in order to prevent wrong operation.
6 operators are not allowed to leave in machine tool machine tool.
7, intermediate frequency pipe bending machine is working, near the tube camber Angle range is not allowed to, and to establish an early warning signal.Pry pipeline, avoid playing slide bar injured.The operator can only standing outside.
8, calibration tube should pay attention to safety, use water hammer;A few minutes, prevent to take off the handle.No wear gloves when using pipe. |
