| The operation technology of pipe bender making pipe bender
In the production process of the pipe bender, the Angle and diameter of the steel pipe that needs to be bent should be input into the control system of the pipe bender under the condition that the pipe bender can be checked and operated normally. In this way, the customized pipe bender can be made continuously during the production of the pipe bender. Adjust the bending effect in the production process, must consider to adjust the amount of joker to effect, after the adjustment type arc bending and sharp pipe length change rate, the degree of circular arc bending pipe is always in the wrong is always after the rain of the pipeline length, adjust the quantity is a size and bending Angle of the radius of the pipe bending machine. Such pipe bender in the production process: simple operation, high production efficiency, low cost of excellent characteristics.
Pipe bender in use: refer to the operation manual of electric oil pump. Now screw the working oil tank into the internal thread of the square block, and the rear end of the oil cylinder is mounted on the wheel on the bracket downward. Choose die according to the bending tube diameter, the fortress, set the column will be two roll groove which corresponds to the die, and then put into the corresponding size of the air, flower board cover plate on the diameter, the bending tube inserted into the slot, jiang in the high pressure oil pipe end quick joint activities section back and set on the joint of cylinder, the oil drain screw on the electric pump tighten, can bend. After the bend is completed, the screw is loosened and the plunger is automatically reset.
Our company mainly produces pipe fitting equipment: pipe bender, elbow machine, tee machine, pipe expanding machine, press, groove machine, straight seam welding pipe production line and other pipe fitting equipment. The above pipe fitting equipment is mainly used in the pipeline installation process.
|
