| The beveling machine is divided into the following characteristics
1, simple structure, durable
The beveling machine power mechanism, cutting mechanism, main bed and work-piece clamping mechanism are all distributed on the frame in parallel and concentric.The whole structure is compact, and the stress of each part is uniform.It is not necessary to re-test the balance degree when the equipment is hoisted and moved. The anchor bolt can be fixed in the process.
2, beveling machine can be equipped with floating tools
Floating tool axis 尜 game can adjust the cutting position of the tool along the inner wall of the pipe fittings at will, the floating amount is 30mm, even if the nozzle has a slight elliptical machining after the groove can be particularly uniform.
3, workpiece clamping convenient and fast
After the workpiece clamping device is fixed on the processing platform and adjusted to an appropriate position, the workpiece to be machined is placed equally (the center of the workpiece is the same as the center of the cutter head of the beveling machine) and the two-clamp V-type device bolts can be tightened.
4, jig tooling can rotate 360°, processing elbow can process another port without unloading, and elbow 90° processing accuracy is higher.
5. Powerful
This equipment uses three-phase asynchronous motor, which has large power, strong anti-overload ability and long service life.
6, wide range of use
This equipment can process straight pipe, elbow, tee, reducing pipe and other round caliber workpieces made of carbon steel, alloy steel, stainless steel and other materials.
Working principle of pipe fitting equipment
Put the cut raw materials on the core rod of the elbow mold, put the intermediate frequency induction wire trap on the end of the elbow mold core, start the cooling water pump and the intermediate frequency power supply, heat the raw materials to about 800°C, and then start the pushing machine to push the elbow.
Select the main push pump according to the elbow, select the speed of feeding, the gate, the mandil rod heated to the working temperature began to push, the work speed is adjustable, push to the middle point of the machine automatically stop, the hydraulic gate gate dead, the core rod feeding, loosen the gate back to the end, the gate gate to the outside diameter of the rod began to push.Note: the main push pump can be used at the same time, generally only one can be used.It can also be used to step back without stopping.Reverse pump can not be used at the same time, only one can start, the other standby.Feeding pump can only be used when feeding.The safety pressure of the main oil pump hydraulic system is set as that of the auxiliary cylinder hydraulic system.There are travel switches at both ends of the push machine travel, the actual travel should be less than the travel, that is, the two ends of the push plate before and after the actual end are left with some margin, so as to avoid the cylinder piston running to.
2212-2304.
|
