The reasons for the problems of pipe bender in use are introduced
In daily use, there will be some problems with the pipe bender. The biggest reason is that when the machine is bending, the pipe material is cut by the metal circular saw, which will leave a lot of small iron pins. It seems that the small iron pins left when cleaning the pipe bender can avoid a lot of problems with the pipe bender.Therefore, special attention should be paid to the small iron pin in the daily cleaning to ensure the normal working efficiency of the pipe bender.
Pipe bender mainly uses oil pump to input hydraulic oil and solenoid valve to provide hydraulic power.So most of the iron pin into the tank after we will make the inside of the inlet pipe of the filter to filter out, but also there will be a small iron pin will enter into the oil pump, this is inhaled into the oil pump iron pin will enter into the solenoid valve, and the iron pin because can't flow in the solenoid valve force result in because of the electromagnetic valve plug,Because the oil can not flow, there will be a pair of action failure, resulting in the pipe bender can not work normally.
The above briefly introduces the causes of the problems in the use of the pipe bender.
How to properly maintain the parts of the pipe bender
The daily use and maintenance of each part of the pipe bender are different.Different parts of the relative maintenance method is also different.When installing the pipe bender, the elbow and the elbow can be directly installed on the pipe bender road according to the specified connection mode.
The first is the elbow of the pipe bender.Elbows placed for a long time should be checked regularly.The surface of some exposed elbow should be kept clean daily, clean up dirt in time, store in a ventilated and dry place indoors, keep the elbow dry and tidy, keep the pipe clean and tidy, and store it accurately according to the storage method provided by the manufacturer.
It is also important to note that the elbow and elbow of the pipe bender can only be installed horizontally, because the medium of the elbow is upstream along the main valve disc.
In addition, if the bending forming speed of the pipe bender is too fast, it is easy to cause the bending part of the pipe to be flat, and the bending degree can not meet the requirements.If the speed is too slow, it is easy to cause wrinkle or deformation of the catheter.In general, there is no special provision for the installation position of the elbow. It can be placed in any position of the pipeline, as long as it is convenient to operate and check.The fullness requirement of R and R point in bending radian of pipe bender is not too high, and the lining diameter should be provided at bending radian points.Double-head pipe bender can not add mandrel when bending pipe, so for the general requirements of bending radian plumpness of the pipe is not feasible, so we say that the bending pipe of the head pipe bender is mainly in the furniture manufacturing industry.When we process the die, we want to do the reverse deformation of the knot die, so that the inner arc of the curved pipe will be strengthened and the pressure resistance of the pipe will be improved.
2108-2109.
| 